A-A-1305
Workmanship. All hammers shall be free from imperfections which may affect their safety, appearance, serviceability, or durability.
The issue of ANSI B173.2 in effect on the date of the solicitation shall apply.
Test:
Handgrip Test. Hammers with handgrips shall be subjected to test. Each samples shall be conditioned climatically to 30 degrees F, plus or minus 2 degrees F, and remain at this temperature for 1 hour or until thermal stabilization has occurred. The sample shall then be cycled to plus 120 degrees F, plus or minus 2 degrees F, and remain at this temperature for 1 hour or until thermal stabilization has occurred. The sample then be conditioned to plus 70 degrees F, plus or minus 10 degrees F (room ambient temperature).
The samples shall then be subjected to a pull test force applied to the grip parallel to the longitudinal axis of the handle with the hammerhead securely captured to restrict movement. In order to minimize normal forces to the handle, the handgrip shall be captured using a woven wire cable grip or suitable device.
The pull test force is to be as noted below, except, that for certain sizes where the handgrip pull test force is found to be greater that the pull-apart force (tensile force). In this instance the handgrip shall be subjected to the head pull-apart force (tensile force) as a maximum in lieu of the specified force.
Grips which loosen or separate from the handle shall be cause for rejection.
After application of the pull test, the hammers shall be held by the head, and the grip twisted at the normal handgrip position by hand in alternating directions with a torque as noted in the table below. Five complete twisting cycles shall be performed, after which there shall be no grip looseness or separation from the handle.
|
HAMMERHEAD |
PULL TEST FORCE |
TORQUE TEST |
|
Less than 16 ozs. |
500 lbs. |
40 in-lbs. |
|
16 oz. and over |
700 lbs |
50 in-lbs. |
Crack detection test. All samples shall be 100 percent inspected and shall be subjected to either a wet magnetic-particle inspection test as described in ASTM E-709-80 or an Ultrascope detection test described in ASTM E 114-75. All surfaces shall be examined. Any hammer exhibiting surface crack indications in any location, may have that indication removed by minor rework. The lot shall be rejected if upon Government acceptance testing any crack indications are found.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business