A-A-52114A
c. The cut pattern shall be six 1/16 to 3/32 inch approximate squares/rectangles.
d. A length of semitransparent tape having an adhesion strength of 40 plus or minus 2.5 ounce per inch of width shall be firmly pressed over the cut pattern. All air pockets under the tape shall be eliminated and the tape shall be firmly adherent to the coating.
e. After 90 seconds, plus or minus 30 seconds, the tape shall be stripped form the coated surface by rapidly pulling the tape back upon itself at 180 degrees plus or minus 30 degrees.
f. The removal off one or more squares/rectangles of coating shall be cause for rejection.
2.7 In-process crack detection test. After heat treating, all mattax heads shall be 100 percent in-process tested for cracks. The test shall consist of a bidirectional wet magnet particle inspection in accordance with ASTM E 709. If a mattax head has one or more surface cracks, the mattax head may be reworked by grinding or buffing to eliminate the surface crack(s); but must maintain the overall weight, shape, and dimensional requirements. All reworked mattax heads shall be retested. All mattax heads presented for acceptance shall have no surface cracks.
2.8 Fit examination. The components shall be assembled as specified in 1.8 and examined for the following defects: carrier too small, i.e., head fails to fit properly into carrier; carrier too big, showing excessive fullness or wrinkles; more than 4 inches of handle above handle loop when inserted; handle not fitting properly into head; more than 1 inch of handle above top of head.
3. Regulatory requirements. The offeror/contractor is encouraged to use recovered materials in accordance with Public Law 94-580 to the maximum extent practicable.
4. PACKAGING
4.1 Overseas.
4.1.1. Packaging. Each head shall be secured into the carrier. The handle shall be attached through the two handle loops. The complete mattax shall be packaged in a fiberboard box with inside dimensions of approximately 24-1/4 by 4-1/2 by 3 inches. replacement handles and carriers need no packaging.
1.1.2 Packing. Six mattax, thirty replacement handles, or sixty replacement carriers shall be packed in a fiberboard box conforming to style RSC-L, grade 275 of PPP-B-636. The inside dimensions of the mattax box shall be approximately 24-1/2 inches in length, 9-1/2 inches in width and 9-1/2 inches in depth. The inside dimensions of the box for the mattax handles shall be
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business