A-A-2938
3.3 Sizes and dimensions. The vise Jaw cap width shall be in accordance with the specified size. The tolerance on the vise jaw cap width shall be plus or minus 1/1 6 inch. The width between the inside of the two end lugs, when bent as shown in figure 1, shall be not less than 1/1 6 Inch nor more than 3/16 Inch greater than the size of the vise jaw cap. The inside height of each end lug shall be 3/8 Inch minimum. The pliable extensions shall be of sufficient length to provide for forming the extensions over the sides of the vise, with the aid of a hammer or mallet. The Inside height of the vise jaw facing shall be 1 inch minimum. The thickness of the vise jaw cap shall be 0.125 Inch minimum and uniform within 1/32 Inch. The vise Jaw caps shall be one of the following sizes, as specified:
|
Size 2 |
For 2 inch width vise jaws |
|
Size 2-1/2 |
For 2-1 /2 Inch width vise jaws |
|
Size 3 |
For 3 Inch width vise jaws |
|
Size 3-1 /2 |
For 3-1 /2 Inch width vise jaws |
|
Size 4 |
For 4 inch width vise jaws |
|
Size 4-1/2 |
For 4-1 /2 inch width vise jaws |
|
Size 5 |
For 5 Inch width vise jaws |
|
Size 6 |
For 6 Inch width vise jaws |
|
Size 8 |
For 8 Inch width vise jaws |
3.4 Identification marking. The vise Jaw caps shall be marked with the
manufacturer’s name or identifying symbol, and the state or country of
manufacture, unless otherwise specified. All identification markings shall be
engraved, etched, molded, or indented directly on the item’s surface in such a
manner that It remains clearly legible throughout the life of the item.
3.5 Workmanship. Details of workmanship shall be in accordance with the
best commercial standards and practices. Paints, coatings, platings, and
finishes shall be smooth adherent, continuous, and not stained or discolored.
External surfaces shall be free of tool and gouge marks, nicks, or other
surface imperfections. The Item shall be free from manufacturing workmanship
defects (e.g. sharp or rough external edges, corners or surfaces) and material
workmanship defects (e.g., pits, rips, fins, burrs, tears nodules, cracks,
blisters) which may adversely impact the item’s serviceability, durability,
safety or appearance.
4. REGULATORY REQUIREMENTS
4.1 Recovered materials. The offerer/contractor is encouraged to use
recovered materials to the maximum extent practicable, In accordance with
paragraph 23.403 of the Federal Acquisition Regulation (FAR).
4.2 Metric products. Products manufactured to metric dimensions will be
considered on an equal basis with those manufactured using inch-pound units,
provided they fall within the tolerances specified (using conversion tables
contained in the latest revision of Federal Standard 376) and all other
requirements of this document are met. If a product is manufactured to metric
dimensions and those dimensions exceed the tolerances specified in the
inch-pound units, a request should be made to the Contracting Officer to
determine if the product is acceptable.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business